Protocol: Sandwich ELISA with streptavidin-biotin detection

This method provides a general procedure for use with the majority of AbD Serotec reagents. In some ‎cases specific recommendations are provided on product datasheets, and these methods should always ‎be used in conjunction with product and batch specific information provided with each vial. Please note ‎that a certain level of technical skill and immunological knowledge is required for the successful design ‎and implementation of these techniques - these are guidelines only and may need to be adjusted for ‎particular applications. ‎

Reagents

1. Coating buffer
Na2CO3, 1.5 g
NaHCO3, 2.93 g
Distilled water, 1 liter, pH to 9.6

For an alternative coating buffer use BUF030

2. Blocking buffer
Phosphate Buffered Saline (PBS) containing 1% w/v BSA

For an alternative blocking buffer, use either ELISA BSA Block (BUF032),ELISA Ultrablock (BUF033), or ELISA Synblock (BUF034)

3. Wash buffer
Phosphate Buffered Saline (PBS) containing 0.05% v/v Tween®-20

For an alternative wash buffer use BUF031

Method

1. Coat microtiter plate wells with 100 μl of the appropriate coating antibody, at a concentration between 1-10 μg/ml in coating buffer. Cover the plate and incubate overnight at 4°C. Wash the plate 3 times in wash buffer.
2. Add 150 μl of blocking solution to each well. Incubate for 60 minutes at 37°C. Wash 4 times in wash buffer.
   NB: For most AbD Serotec antibodies this step can be omitted without having any deleterious effects on the results obtained.
3. Add 100 μl of suitably diluted samples to the relevant wells. Ensure that appropriately diluted standards are included (dilute samples and standards in wash buffer). Samples or standards should preferably be run in triplicate. Incubate for 90 minutes at 37°C or overnight at 4‎°C‎. Wash 3 times in wash buffer.
4. Add 100 μl of biotin-conjugated detection antibody (appropriately diluted in wash buffer) to each well. Incubate for 1 hour at 37°C. Wash 3 times in wash buffer.
5. Add 100 μl of enzyme-conjugated streptavidin (appropriately diluted in wash buffer) to each well. Incubate for 60 minutes at 37°C. Wash 3 times in wash buffer.
6. Add 100 μl of the appropriate substrate solution 1 to each well. Incubate at room temperature (and in the dark if required) for 30 minutes, or until desired color change is attained.
7. Read absorbance values immediately at the appropriate wavelength.
8. OR add 50 μl of “stop solution”. Gently tap plate to ensure thorough mixing. Measure absorbance within 30 minutes.

Recommended Substrates and Stop Solutions

TMB (BUF042), for use with HRP-conjugated antibodies. Stop with 2M H2SO4.
pNPP (BUF044), for use with alkaline phosphatase-conjugated antibodies. Stop with 1M NaOH.